top of page

RST2™ Level Transmitter

The RST2 sensor is a chain of magnetic reed switches and resistors mounted within a heavy wall stainless steel tubing assembly. As the float within the Magnicator responds to liquid level change in the chamber, the float actuates adjacent reed switches. The reed switch and resistors provide a varying resistance output. It is this output that is measured by the RST2 electronics module, as an indication of liquid level. The RTS2 transmitter will provide a 4-20 mA signal proportional to the liquid level indicated by the Magnicator.

  • Two-wire, 4-20 mA loop powered, proportional transmitter

  • Sensing lengths from 6 inches to 228 inches (15 cm to 6 meters)

  • Continuous level measurement with 1/2″ resolution

  • UL/CUL approved for use in hazardous locations:

    • Class I, Division 1 Groups B, C, D

    • Class II, Division 2 Groups E, F, G

  • Electronics housed in NEMA 4X, 7 (Groups B, C, D) and IP 66/67 enclosure

RST2™ Level Transmitter
RST2™ Level Transmitter on level gage
bottom of page